Leica Geosystems Leica 3D Disto - Manual - Manual (Page 22)

3D Disto, Technical Terms and Abbreviations 22
Secure Points Secure Points link measurements to a coordinate system. These reference points
allow changing the 3D Disto’s location or continuing measurements at a later time,
so that all measurements fit together perfectly.

Refer to "7.3 Location" for more information.
1. Name and place three to five self-adhesive
target marks on walls, ceiling or floor around
your working area.
2. Measure these target marks and save them as
Secure Points.
3. Move the 3D Disto or set it up "anywhere" at
a later time.
4. Measure the Secure Points again. 3D Disto
relocates itself and measurements can be
continued.
3D Disto_026
3D Disto_027