Leica Geosystems Leica 3D Disto - Manual - Manual (Page 124)

3D Disto, Software Applications 124
8. If Yes: Folder opens to choose next Secure Point. Proceed as described in 4. to
7. for 2
nd
and 3
rd
point.
9. When you have measured three points successfully a pop-up shows OK.
Measure more Secure Points? Yes/No/Cancel.
10. Press Yes to continue and proceed as described in 4. to 7.
11. Press No to finish. If successful, a pop-up displays the dimensions between old
and new position: XXXm; Height: XXXm; OK/Cancel. Accept with OK or Cancel
to measure further points.
12. If Relocation was not successful, pop-up prompts Out of tolerance! Measure
more Secure Points? Yes/No/Cancel. Go on as described in 4. to 11.
13. Press to close the application.

If the first two Secure Points were measured successfully the 3D Disto
roughly turns to the next chosen Secure Point. You just have to do the
fine targeting and press .