Leica Geosystems Leica 3D Disto - Manual - Manual (Page 166)

3D Disto, Software Applications 166
2. Laser point flashes if the exact position is found. Point is highlighted in red in
sketch area.
To layout further points select another point and press .
3. Press to go back to the Aligner tool.
4. Press to save the file.
Plane Switching 
If a point can not be projected on the ceiling, just move the laser beam
onto the floor before pressing the DIST key. Following points will be
projected on the floor from now on. The projection surface can be
changed at any time.