Leica Geosystems Leica 3D Disto - Manual - Manual (Page 168)

3D Disto, Error Messages 168
8 Error Messages
Error messages and
advice
Error no. Advice
150 Working range was exceeded.
151 Invalid measurement.
152 Change 3D Disto's position or use ruler for offset points.
160 Repeat and do not move the ruler between both measurements.
161 In some cases the Offset Point tool can not be used.
170 Restart 3D Disto if the problem persists.
171 Check all devices, for example power supply or cables, and try again.
240 Tilt sensor calibration was not successful. System accuracy is at risk.
Contact your distributor or Leica Geosystems representative.
241 Too much drift. Repeat calibration precisely.
243 Set up instrument stably. Do not touch or rotate the 3D Disto. Repeat
calibration.
300 Select a horizontal line.
350 Check projection surface. Laser could not reach the correct position.