Leica Geosystems Leica 3D Disto - Manual - Manual (Page 176)

3D Disto, Check & Adjust 176
Adjustment
step-by-step
6. If both measurements were successful, a pop-up appears with Set new:
XXX gon, Reset to factory default, or Cancel calibration.
7. Choose Set... or Reset... to adjust V-index. Final pop-up asks Are you sure?
Yes/Cancel.
8. If Yes, checkmark is displayed to confirm parameters were set successfully.
1. Set up the 3D Disto close to a wall with a steep target of
good visibility that is at least 15 m above the instrument.
2. Press .
3. Viewfinder opens. Target as precisely as possible.
Press .
4. 3D Disto turns to second face automatically.
5. Target a second time. Press .
3D Disto_051