WEATHER GUARD Model 96121-3-01 Window Bulkhead, Mid/High-Roof, Mercedes-Benz Sprinter - Manual (Page 2)

2
INSTALLATION INSTRUCTIONS
FOAM PAD
A
B
C
D
E
H
F
G
PARTS LIST
Qty. Description
A 1 Passenger Side Panel
B 1 Driver Side Panel
C 1 Center Panel
D 2 Door Pockets
E 1 High Roof Header Panel
F 1 Driver Side Filler
G 1 Passenger Side Filler
H 1 Standard Roof Header Panel
1 Panel
1 Bolt Kit – Part #32-0198
STEP 1. If the Sprinter (Standard or High Roof) has
Foam Pads in the upper corners behind the B-Pillar
they will have to be removed. They are designed to
stay in place without fasteners and will have to be
broken to be removed. They will not be needed after
the Bulkhead is installed.
The Sprinter (Standard of High Roof) will either have
the B-Pillar exposed towards the rear of the vehicle
or it will be entirely covered by B-Pillar molding.
If the molding covers the entire B-Pillar it will have
to be temporarily removed for Bulkhead installation
and then cut to fit after the Bulkhead is installed and
before the vehicle is placed in service.