WEATHER GUARD 1910 - Manual

WARNING
This product can reduce the driver’s ability to clearly see road-
ways, vehicular or pedestrian traffic and other objects through the
rear and side windows of the vehicle, which may cause an acci-
dent. Extra precautions should be taken when driving a vehicle
with this product. Make all adjustments necessary to ensure max-
imum visibility, including but not limited to, changing mirror and
seating positions. State and local laws may prohibit obstruction
of windows in a moving vehicle.
INSTALLATION INSTRUCTIONS
PROTECT-A-RAIL® Cab Protector Model 1910 (For Mini Pickups)
IMPORTANT
BEFORE YOU BEGIN
Read these instructions and
warnings completely before
installation.
BOLT KIT
Bolt Kit #32-1910 has been provid-
ed with your PROTECT-A-RAIL®
Cab Protector. Check this bolt kit to
be sure the following parts are
included:
Quan. Description
14 5/16-18 x 1-1/2" Hex Bolt
10 5/16" Lock Washer
17 5/16" Flat Washer
10 5/16-18 Blind Fastener
1 Installation Tool
1 5/16-18 x 2-1/4" Black
Oxide Bolt
5 5/16-18 Nylon Lock Nut
TOOLS REQUIRED
• Electric Drill w/ 3/8" & 1/2" bits
• 1/2" Open or Box End Wrench
• Carpenters Square
• 9/16" Open or Box End Wrench
PARTS LIST
• 1- PROTECT-A-RAIL®
Cab Protector
• 2- "Z" Mounting Brackets
• 2- Reinforcing Brackets
PROTECT-A-RAIL®
Cab Protector Reinforcing
Bracket
"Z" Bracket
CAUTION
To keep debris out of your eyes
when checking the underside of
the vehicle, or when drilling,
always wear protective eyewear.
INSTALLATION
INSTRUCTIONS
1. Install two Reinforcing Brackets
in front corners of truck bed, as
shown in Fig. 2. Place the brackets
in position and mark the holes
indicated on the bed. Drill four 3/8"
holes (per bracket) first, then
redrill the four holes in the front of
the bed with a 1/2" drill. Install
Blind Fasteners in these four holes
(Blind Fastener instructions on back
page). Secure brackets. (If the
PROTECT-A-RAIL® unit is being
installed on a Ford Ranger, do
not install the inner most bolts
on the Reinforcing Brackets).
(See Fig. 4)
Figure 1.
Figure 2.
Approximate Assembly and Installation time:
24 min. per unit (0.4 hrs.) Depending on truck equipment installation
experience.
Lockwasher
5/16-18
Nylon Lock Nut
Blind
Fastener
Flat Washer
5/16-18x1-1/2 Bolt
The distinctive, trademarked
RED TIPS are your assurance of
WEATHER GUARD® Equipment
quality.
Part No. 24-0091 REV. B ECN 5305 04/13