WEATHER GUARD 1259 - Manual

BOLT KIT
Bolt Kit #32-0169 is provided with
your Accessory Screen. Check
this bolt kit to be sure the following
parts are included:
Quan. Description
15 1/4x3/4 Self-Drilling Screw
4 5/16-18 x 3/4" Bolt, self-
tapping
4 3/8-16 x 3/4" Bolt, thd.
cutting
PARTS LIST
• 1- Screen Frame
• 1- Screen
• 4- Screen Sockets
• Cushion Strip (bulk)
• Tube E-6000 Sealant
TOOLS REQUIRED
• Electric Drill
• 1/4" Drill Bit
• 5/16" Drill Driver Bit*
• 1/2" & 9/16" Open or Box End
Wrench
* If you do not have a drill driver,
you will need a 3/32" drill bit and a
5/16" wrench or nut driver.
ASSEMBLY AND INSTALLATION INSTRUCTIONS
Accessory Screen - Models 1259 and 1359
(Model 1259 fits 1245 & 1275 racks. Model 1359 fits 1345 & 1375 racks)
WARNING
This product can reduce the driver’s ability to clearly see road-
ways, vehicular or pedestrian traffic and other objects through
the rear and side windows of the vehicle, which can cause an
accident. Extra precautions should be taken when driving a ve-
hicle with this product. Make all adjustments necessary to en-
sure maximum visibility, including but not limited to, changing
mirror and seating positions. State and local laws may prohibit
obstruction of windows in a moving vehicle.
IMPORTANT
BEFORE YOU BEGIN
Read these instructions and
warnings completely before
assembly and installation.
ASSEMBLY
INSTRUCTIONS
1. Lay the Screen Frame face down,
with the weld nuts facing down. Care-
fully center lengths of Cushion Strip
onto the frame so adhesive makes
good contact.
2. Place the Screen on the cushion
strip and carefully center it. Fasten
the screen to the frame.
NOTE: If you do not have a drill
driver, pilot holes will have to be
drilled for the self drilling screws.
Use a 3/32" drill bit.
Part No. 24-1259 REV. D ECN 5315 05/13 1