WEATHER GUARD 239 - Manual

ASSEMBLY AND INSTALLATION INSTRUCTIONS
CONDUIT CARRIER - Model 239
IMPORTANT
BEFORE YOU BEGIN
Read these instructions and
warnings completely before
installation.
Rev. D 4/97 Part No. 24-0239
NOTE: Use only the recom-
mended ASTM material, which
is PVC 1120 Schedule #40.
The 6" diameter pipe should
fit snugly on the end cap. If it
does not, this is an indication
that you have the wrong size
pipe. Be sure to follow appli-
cation instructions found on
the cement container.
4. Assemble Rear End Cap to PVC
pipe. Apply a thin coat of Plastic Ce-
ment to the inside flange of the end
cap...then quickly apply a liberal ce-
ment coat around the outside of the
PVC pipe.
5. While the cement is still wet, push
the End Cap onto the PVC pipe with
a slight turning motion until it is fully
seated on the pipe.
NOTE: Keep pressure on the end
cap for approximately 30 seconds
for a good seal.
6. To assemble the Front Cap to the
PVC pipe, repeat steps 4 and 5,
making sure the Triangular Tab lines
up with the center of the hinge pin on
the rear end cap (
see Figure 1.).
ASSEMBLY AND
INSTALLATION INSTRUCTIONS
1. Be sure the 6 in. PVC Pipe is cut
squarely on both ends and to correct
length (10 ft.). Any rough edges should
be smoothed with a file.
2. Before cementing the end caps in
place, be sure to clean away any dirt,
grease or moisture from both ends of
the PVC pipe.
3. Use a plastic primer to remove sur-
face gloss from pipe ends and inside
flanges of end caps.
NOTE: Keep the door End Cap open
during priming, gluing and curing
steps to prevent possibility of sealing
the door shut.
WARNING
This product is only intended for, and only safe for, storing and
transporting tubing, pipe and conduit. Any modifications made
to this product, or use of this product for any other purpose than
its intended use, could create a hazardous condition that can
cause serious personal injury or property damage.
BOLT KIT
Bolt kit #32-2390 is provided with
your Conduit Carrier. Check this
bolt kit to be sure the following
parts are included:
Quan. Description
4 #12-24 Nylon Lock Nuts
(black dichromate)
PARTS LIST
• 2 - "U" Clamps
• 1 - Front End Cap
• 1 - Rear End Cap with Door
• 4 - Clamp Brackets
TOOLS & MATERIALS
NEEDED
• 3/8" Open or Box End Wrench
• Plastic Pipe Cement
• PVC Primer
• PVC Pipe