WEATHER GUARD 201 - Manual

KNAACK
LLC
420 E. TERRA COTTA AVENUE - CRYSTAL LAKE, ILLINOIS, 60014 - 815-459-6020
@ 2013 ©Knaack LLC
ASSEMBLY AND INSTALLATION INSTRUCTIONS
Model 201
If you have any questions, please give us a call.
Call Toll Free 1-800-456-7865
WEATHER GUARD® products are protected by one or more of the following trademarks:
U.S. - 842268, 1661625, 1663369, 2228051; Canada - 282725; U.K. - 1400720; other trademarks pending.
INSTALLATION
INSTRUCTIONS
1.
Pull both end Drawers out com-
pletely. Place mounting brackets
on the drawer unit, align surface
holes, then fasten.
2.
Place unit inside, all the way
against the rear wall. Mark through
the mounting bracket holes for lo-
cation and remove the unit.
BOLT KIT
#32-0152 has been provided with
this model. Check this bolt kit to be
sure the following parts are in-
cluded:
Qty. Description
8 1/4-20 x 5/8" Hex Hd. Bolts
8 1/4-20 nylon lock nut
TOOLS REQUIRED
•
Electric drill with 5/16" drill bit
•
7/16" open or box end wrench (2)
IMPORTANT
BEFORE YOU BEGIN
Read these instructions com-
pletely before installation.
Drawer Unit
1/4-20 Nylon
Lock Nut
1/4-20 Nylon
Lock Nut
Hi-Side
Box
Mounting
Bracket
1/4-20 x 5/8"
Bolt
1/4-20 x 5/8"
Bolt
Drawer
3.
Drill the holes in the side box.
4.
Place assembled drawer unit into
side box and fasten with remainder
of bolts and nuts.
CAUTION
To keep debris out of your eyes
when checking the underside of
the vehicle, or when drilling, al-
ways wear protective eyewear.
- NOTICE -
Any modification or unintended use of this product shall immediately void all manufacturers warranties.
Manufacturer disclaims all liability for injuries to persons or property resulting from any modification to, or
unintended use of this product.
Part No. 24-0201 REV. D ECN 5315 05/13