WEATHER GUARD 164-X-01 THRU 186-X-01 - Manual

1
INSTALLATION MANUAL
STEEL & ALUMINUM SIDE BOX
MODELS 164-X-01 THRU 186-X-01
ATTENTION: PLEASE READ AND UNDERSTAND ALL INSTRUCTIONS AND WARNINGS
BEFORE ASSEMBLING, INSTALLING OR USING THIS PRODUCT.
WWW.WEATHERGUARD.COM
TRUCK STORAGE SOLUTIONS
SECURING YOUR REPUTATION ®
PRODUCT REGISTRATION
Model# ________________ Serial#__________________
Purchased Date:
______________________
Place of purchase:
______________________
Key Code:
______________________
For your convenience,
place product
registration tear-off
sticker here.
*24-0199* Part No. 24-0199 REV. C ECN 5305 04/13
DANGER
Danger of explosion. Do not use this product for storing or transporting flammables, explosives, hazardous materials, or hazardous
waste, such as containers of gasoline, solvents, gun powder, dynamite, propane tanks, acetylene tanks and cutting torches. This
product is only intended and safe for use in storing and transporting small tools, equipment and other similar materials. Any
modifications made to, or unintended use of this product, could create a hazardous condition that can cause death, serious
personal injury or property damage.
CAUTION
Before marking the leg mounting holes, check inside the box for location of gas spring housing and components that may obstruct
safe drilling.
To keep debris out of your eyes when checking the underside of the vehicle, or when drilling, always wear eyewear.
WARNING
To keep debris out of your eyes when checking the underside of the vehicle, or when drilling, always wear eyewear. Prior to drilling,
so as not to cut or puncture fuel tanks, fuel lines, brake lines, electric wires, etc., check under vehicle for locations. All floor mounting
bolts near the gas tank area should be installed from the underside of the vehicle, to guard against the gas tank being punctured in the
event of a collision. This would mean not using Blind Fastener in this area. Holes drilled in this area should be 3/8”.
- NOTICE -
Any modification or unintended use of this product shall immediately void all manufacturers warranties. Manufacturer disclaims all liability
for injuries to persons or property resulting from any modification to, or unintended use of this product.
INSTALLATION TIME
Approximate installation time:48 minutes per unit (0.8 hours) depending on truck equipment installation experience .