Allen&Heath GLD-112 Reference Guide - Manual (Page 53)

GLD Touch Screen Reference V1.4 – Issue 1 53 ALLEN & HEATH
13. Setup Screen – Utility
13.1 Diagnostics page
View the system Event Log here.
This keeps a timed log of events such as system boot up or
shut down, and when Scenes or other memories were
recalled. It also logs any errors recognised by the system.
If you suspect a problem with the GLD you can copy the log
to USB key and send it to Allen & Heath Technical Support
for diagnostic purposes.
13.2 Date/Time Setup page
Use this screen to set the current date and time.
The time is displayed in the
Home screen and is used in the
Event Log.
To change the Date – Scroll << or >> to the required
month and touch a date box.
To change the Time – Touch the Hour, Minute or Second
box to highlight it. Use the screen Rotary to set the value.
Press Apply to accept the changes or Cancel to return
without changing the settings. Changing these settings will
automatically restart the touch screen.
13.3 Calibration Setup page
The Calibration Setup page lets you recalibrate the
accuracy of the touch screen or motor faders.
To calibrate the Touch Screen – Touch the Calibrate
button. As accurately as you can touch the circle at the top
left of the screen. Repeat for the other three corners.
To finish, touch the Press to Confirm button. This ensures
that the calibration is correct. If it is not and you are unable
to select the button the screen will time out and the
previous calibration be restored.
To calibrate the Motor Faders – Touch the Calibrate
button. Follow the on-screen instructions and touch Next
after each step. Set the faders to the positions instructed.
Finally, touch Finish to complete the calibration.
Note The ‘+10dB’ and ‘-Inf’ positions are those marked on
the panel, not the top or bottom of travel of the faders.
Note It may be necessary to re-calibrate the motor faders
after you update the GLD system firmware or perform a full
system reset.