Allen&Heath GLD-112 Reference Guide - Manual (Page 37)

GLD Touch Screen Reference V1.4 – Issue 1 37 ALLEN & HEATH
7.6 Scene Safes page
Scene Safe is similar to the Recall Filter but is global
affecting recall from all Scenes.
Use the tabs on the left of the screen to view the different
parameter groups. Swipe your finger up/down or left/right
to navigate through the list.
To make a channel or master fully Recall Safe - Either:
1. Surface keys - Hold the
Safe key and press the Mix key
for the channel you wish to make Safe, or
2. Screen - Touch the channel number label on the left of
this screen to turn on all its parameters Safes.
When a channel or master is fully Safe the ‘SAFE’ icon will
appear at the top if its strip LCD display.
Note The ‘SAFE’ icon will only appear if all the channel
parameters are Safe.
Note Making a channel Safe in this way overwrites
previous settings in the Scene Safes page.
To make selected parameters Recall Safe
1 - Single items - Touch to toggle a button.
2 - One parameter for all channels - Touch label at top.
3 - All parameters for one channel - Touch label on left.
4 - All items in the current tab - Touch Toggle All.
Safes are applied immediately. No confirmation is needed.
Safes settings are stored in Show memories.
4 3 2 1
Scene Safes parameters
For Inputs, FX Returns, FX mix, Grp, Aux, Main Mtx:
Preamp Gain, Pad, and 48V
Trim and Polarity
HPF
Insert In/Out and operating level
PEQ
GEQ
Dynamics – Gate, Compressor and Limiter
Channel Fader
Channel Mute
Channel Pan
Routing assignments, Sends and Pan
Delay
Direct Out
DCA assignments
Name and Colour
Parameters that can be made Safe for DCA Groups:
Channel assignments
Master Fader
Master Mute
Name and Colour
FX parameters:
Parameters for each of the 8FX units
SoftKeys:
Settings for each of the 10 SoftKeys
Other parameters that can be made Safe:
Patchbay – Input source, Inserts, Outputs
I/O Port – Option card settings
Output Polarity
Talkback HPF
Ganging
dSNAKE Monitor – Aviom/ME mode
Global Direct Out
Strip Assigns – Left and/or Right banks
Note From V1.1 onwards making all items Safe will prevent
any GLD parameters being overwritten when any Scene is
recalled.
A blue dot lights in a screen tab when one or more items
have been made safe within that page.