Allen&Heath GLD-112 Reference Guide - Manual (Page 34)

GLD Touch Screen Reference V1.4 – Issue 1 34 ALLEN & HEATH
7.2 Scene Crossfade
A crossfade time can be set for each Scene. This is the time
it will take to fade the current levels to those in the Scene
when it gets recalled.
Crossfade affects:
Input faders and pan
Master faders
DCA fader levels
Aux send levels and pan
Matrix send levels and pan
Note Crossfade affects the audio levels but is not shown
on the faders which move instantly to their new positions.
Crossfade Time - Sets how long it takes for levels and pan
to change to the settings of the Scene being recalled.
Default Scene recall is instant (0 sec), but you can be set a
crossfade time up to 20 seconds per Scene.
7.3 Embedded Scene Recall
You can choose to automatically recall one or more other
Scenes from the same or a different unit when you recall a
Scene. A delay time can be set for each Scene embedded
within the host Scene.
Touch the Embedded Recall button to open the popup.
Add New Embedded Recall
Unit Name - Touch the box to open a list of all compatible
Allen & Heath units found on the GLD network. For
example, this could include other GLD mixers, iLive
systems and iDR-4 or iDR-8 mix processors. Select the unit
to recall the Scene from. Select 'Local Unit' to embed
Scenes from this GLD mixer.
Scene Number - Touch and use the Rotary to select the
Scene you wish to embed. Its name is displayed below the
box.
Delay - Set the delay time for the embedded Scene recall.
This is the time it waits before being recalled after you have
recalled the host GLD Scene. Time can be set from 0 sec
(instant) to 4 minutes.
Add - Touch to add the selected Scene and its delay time
to the list on the right. It is typical to add just one embedded
Scene, but you can add others, each with the same or
different delay time.
Current Embedded Recalls list
The list shows the Scenes currently selected to be recalled
within the host Scene. The associated unit and delay times
are displayed.
Remove - Touch to remove an embedded Scene within the
list. Remove and add again if you wish to edit the delay
time.
To exit the Embedded Recall popup - Touch the screen
outside the popup.