Garmin GPS 89 User Manual
Page 58
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

3
A/í's.sfijjrs íiiiíl
7(iitr *0//st’(s
The
GPS
89
uses
a
flashing
on-screen
message
indicator to alert you to important information. Whenever the
message indicator appears, press PAGE to view the message
page. There are two types of messages: temporary alerts and
condition alerts. Temporary alerts are cleared from the message
page after viewing, while condition alerts remain until the con
dition has been resolved. Pay careful attention to all messages
for your own safety.
Accoracy has been Degraded—The accuracy
of the GPS 89 has been degraded beyond 300
meters due to poor satellite geometry or data
tjuality. You should check other navigaiionat
sources to verily the position indicated.
Already Exist]—The name you are entering
already eidsts in the GPS 69S memory.
Approaching—You are one minute away horn
reaching a destination waypoint.
Arrival At—You ate within the arrival alarm cir
cle of die itrdicated waypoint.
Battery Power 1* Low—The batteries are low
and should be replaced.
Cannot Navigate Locked Pont«—You have
attempted to navigate a route with a locked way-
poinl. A waypoint can be locked’when ihe data
base is updated 1f the waypoint does not eidst in
the new database.
Can’t Cha^ Active №ypoint—You have
attempted to change the 'Active To' or 'Active
From’ waypoint Clear the active route or GOTO
before making your changes.
CDl Alarm—Youi course deviation has exceed
ed the Ihnh specified on the alarms setup page.
Final Allhade Alert—The current aldlude is
within 1000 feet of ihe final altitude entered on
the VNAV page.
Inside SUA—Your aircraft has entered the
boundaries of special use or comtolled airspace.
Not Smoothed—The upcoming route leg
is too short for smooth waypwnt transitions.
No DCFS Position—Not enough data is avail
able to compute a DGPS position.
No KTCM Input—The beacon receiver is
improperly connected or baud rates do not match.
Poor GPS Coverage—The GPS 89 cannot
acquire ihe necessary number of saielliics to
compute a position. Try another location with a
clearer view of the sky
Power Down and Re-init—The GPS 69 is not
able to calculate a position due to abnormal
satellite conditions. Turn the unit off and verify
the last position shown by other means. Tty the
unit again later, possibly in a different location.
Read Oily Mem has Failed—The permanent
memoty has failed and the unit is not operable.
Take your unit to an authorized GARMIN dealer
for repairs.
Received an InvaUd WPT-^ waypoint was
received during upload tiansfei that has an
invalid idemther.
Receiver has Failed-^ failure in receiver
hardware has been detected. If this message per
sists, do not use ihe unit and take it to an autho
rized dealer for repair.
Ronu U Fnl^-You have atrempttd to add
more than 30 waypoints to a route.
Route is not Empty—You have attempted to
copy into a route already in use.
Route Vi^ypohit Can’t be Deleted—The way-
point you are trying to delete is part of a route.
Delete the waypoint from the route before
removing it from memory
Route 'Wtypomt was Deleted-^ route way-
point entered does not exist in the database and
has been deleted from the route.
RTCM Inpnt has Failed—DGPS data being
received has been lost. You are no longer receiv
ing the beacon signal.
54