Welch Allyn Connex Vital Signs Monitor PMP Tab Instructions - Quick Reference Guide - Manual (Page 15)

PMP calibration and verification setup
Test equipment part numbers
The equipment detailed in the table below are used for PMP calibration and verification. Contact
Welch Allyn Customer Service to purchase or locate specific parts.
Part number Description Quantit
y
01802-110 Tester, calibration, 9600 Plus 1
5082-183 Masimo tester (Masimo part number 2368) 1
Masimo LNC-10 cable (Masimo part number 1814) 1
DOC-10 Cable, SpO2 extension, Nellcor 1
SRC-MAX Cal-key, assembly, M690/692 1
06138-000 BP Y-tube, no fittings, 1/8 tube 1
4500-925 USB 2.0/5-pin Mini-B cable, gold, 6 feet 1
715701 PMP service test box 1
200-21000IN Pressure meter, Netech 1
401028 BP test volume repair fixture 1
OTS item Netgear router, a/b/g or equivalent 1
OTS item Ethernet cable 1
OTS item NIBP dual USB cable 1
OTS item BP T-tube, no fittings, 1/8 tube 1
97S775 Bulb, large, with air release valve 1
Dual lumina cuff end connector 1
Single lumina cuff end connector 1
11