Welch Allyn 408 Micropaq Monitor - User Manual - Manual (Page 23)

2
19
Monitoring
Connect a new patient
Connect to the network
1. Insert a battery into the monitor to turn it on. After a few seconds the monitor Power-
Up Screen is replaced by an initial monitoring screen.
2. After the network connection is established, the monitor may prompt you to select an
Acuity Unit (if your facility has more than one Acuity unit):
If any patient cables are
connected, there will be
some patient data displayed.
The format depends on the
monitor default settings.
Example of Initial Monitor Screen
The monitor is
searching for a
network
connection.
Possible Acuity Unit
selections.
Press to view more.
Example of Acuity Unit Selection