Rice Lake SCT-10 - Manual (Page 19)

Configuration 15
2. Press , FS-tEO is displayed.
3. Press or until NASS is displayed, press . LED’s will
begin scrolling.
4. Press or until desired capacity is displayed, press .
5. Press twice to exit set-up menu.
2.1.3 Zero Setting
Perform this procedure after having set the “Theoretical Calibration” on page 14.
This menu may also be accessed directly from the weight display,
press and hold for 3 seconds.
1. Press and hold , then press . CALIb will be displayed.
2. Press , FS-tEO is displayed.
3. Press or until ZErO is displayed, press .
4. The weight value to be set to zero is displayed. In this phase all of the
LEDs are flashing. Press , the weight is set to zero (the value is
stored to the permanent memory).
5. Press twice to exit set-up menu.
Press to display the accumulated deadload that has been
zeroed off by the instrument, displaying the sum of all of the
previous zero settings.
2.1.4 Zero Value Manual Entry
Perform this procedure only if it is not possible to reset the
weighed structure tare, for example because it contains
product that can not be unloaded.
Set in this parameter the estimated zero value.
1. Press and hold , then press . CALIb will be displayed.
2. Press , FS-tEO is displayed.
3. Press or until INP 0 is displayed, press . LED’s will
begin scrolling.
4. Press or until desired dead load is displayed, press .
5. Press twice to exit set-up menu.
MENU
TARE PRINT MENU
TARE PRINT MENU
0
ESC
Note
0
ESC
MENU
0
ESC
MENU
TARE PRINT MENU
MENU
0
ESC
Note
TARE
Important
MENU
0
ESC
MENU
TARE PRINT MENU
TARE PRINT MENU
0
ESC