Rice Lake PR5220 Ethernet Transmitter - Manual (Page 83)

PR 5220 Instrument Manual Commissioning
Sartorius EN-83
4.6 Calibrating Digital Load Cells Type ‘Pendeo®’
4.6.1 General Information
The digital load cells have been calibrated at the factory based on the acceleration of gravity Hamburg,
Germany: 9.81379 m/s². The calibration data in the load cells are invariable. The calibration data for the
gravity acceleration at the place of installation can be adapted only in the instrument and protected against
overwriting (see Chapter 4.1.1). With applications for use in legal metrology, the legal requirements and the
conditions given on the test/approval certificate must be taken into account when selecting the settings.
For connecting digital load cells (xBPI load cells) a Firmware from 2.10 onwards is required.
4.6.2 Viewing the Interfaces
The existing interfaces can be viewed under -[Show HW-slots]:
Info/HW-Slots
Builtin RS485 Built-in interface
Builtin analog out
Built-in interface
Builtin digital I/O
Slot 4 PR5220/01 Profibus-DP
4.6.3 Selecting and Setting up the Interface
Select -[Serial ports parameter]-[xBPI-Port] to choose a serial interface.
Setup/ Serial ports
Remote display -none-
SMA -none-
xBPI-Port Builtin RS485 Press
to select RS-485.
Press [Param].
Param
The menu appears.
Setup/Serial ports/ Slot2 RS485
Assigned to xBPI-Port
Protocol xBPI
Baudrate 19200 bd
Press to select the value ‚19200 bd‘.
Bits 8
Parity odd
Stopbits 1 Press
to select the value ‚1‘.