Rice Lake PR5220 Ethernet Transmitter - Manual (Page 127)

PR 5220 Instrument Manual SMA Protocol
Sartorius EN-127
Requesting the High-Resolution Weight
Command: R
Reply:
The scale immediately returns the high-resolution (10x) weight and status: Gross weight if not
tared, net weight if tared.
Note: The gross/net status is shown in lower-case letters while the high-resolution weight is
sent.
For details, see page 130.
Requesting the High-Resolution Weight with Stability
Command: Q
Reply:
The scale returns the weight and the status only, when the stability condition is met: Gross
weight if not tared, net weight if tared.
For this function, the stability condition must be met. The maximum waiting time for stability is
set under [Tare timeout]; see Chapter 4.4.13.
After elapse of the waiting time without reaching stability, the following reply is sent:
<_><1><_><----------><___>
For details, see page 130.
Requesting the High-Resolution Weight Continuously
This is a command which generates non-requested replies, because it does not function according to the strict
pattern of command and reply. After the command, the scale repeats the reply continuously.
Command: S
Reply:
The scale repeats the weight and status information continuously until another command is
received.
For details, see page 130.
Dependent on the used baud rate, the repetition rate of reply telegrams is roughly as follows:
19200 bd
 100ms
9600 bd  110ms
4800 bd  170ms
Requesting the Tare Weight
Command: M
Reply:
The scale returns the tare weight and signals the 'tared' status in the status character.
For details, see page 130.