Rice Lake MSI-8000 RF Remote Display - ScaleCore Configuration Management Program (ScCMP) User Manual
Page 7

Installation
3
Manual Connection
1. Select
File
, then
Open Communications
. ScCMP will display the connection parameters dialog. This dialog
allows you to manually enter either Serial (RS-232) or IP host address and port for the device connection.
Typical serial connection parameters are:
- Baud Rate – 9600 baud
- Parity – None
- Data Bits – 8
- Stop Bits – 1
- Flow Control – None
Figure 2-2. Communications Dialog (RS-232)
2. Select the serial port name of the local computer port that the ScaleCore device is connected to.
3. Press
OK
to open the connection.
Ethernet and WI-FI
Ethernet and Wi-Fi (802.11) communications require the IP address and port number of the ScaleCore device. The
address is specific to the device installation. The port is typically 2101.
The last used connection
parameters are
automatically entered.
Note
Figure 2-3. Communications Dialog (TCP/IP)
- MSI-7300 Dyna-Link 2 - ScaleCore Configuration Management Program (ScCMP) MSI-4260 Port-A-Weigh - ScaleCore Configuration Management Program (ScCMP) MSI-3460 Challenger 3 - ScaleCore Configuration Management Program (ScCMP) MSI Tension Dynamometers - ScaleCore Configuration Management Program (ScCMP) MSI Indicators/Remote Displays - ScaleCore Configuration Management Program (ScCMP) MSI Crane Scales - ScaleCore Configuration Management Program (ScCMP) Crane Scales - ScaleCore Configuration Management Program (ScCMP)