Rice Lake MSI-8000 RF Remote Display - ScaleCore Configuration Management Program (ScCMP) - Manual (Page 25)

Advanced Configuration 21
6.2 Sensors
The advanced sensor view provides a list of all sensor types and their associated configuration.
Figure 6-2. Configuration View - Sensors
6.2.1 Parameters
Table 6-2. Sensor Parameters
Parameter Description
ID Sensor ID index for every type of sensor. Typical range 0 to 16.
Enabled Enable or Disable the sensor.
Type Sensor type, dependent on the hardware configuration.
Name Name of this sensor. Maximum number of characters is 20.
CnvSpeed
Sensor conversion speed range 1 to 15. Smaller value faster the speed and more noise. This value is
hardware dependent.
ACExc AC Excitation feature enabled. This feature is not yet supported in many ScaleCore products.
TempComp Temperature Compensation feature enabled. This feature is not yet supported in many ScaleCore products.
Vref Voltage Reference enable. This feature is hardware dependent.
SWFilter The software filter level for the sensor. Typical range 0-3 where the lower number is less filtering.
Motion Enabled Enable or Disable motion detection.
AZM Enabled Enable or Disable AZM (Auto Zero Maintenance) algorithm.
Zero at Power Up Enable or Disable automatic zero of load at power up.
Standard Mode Set the weighing mode (Industry, NTEP, OIML, 1-Unit).
6.2.2 Controls
Edit Sensor – This control allows editing the sensor configuration parameters.
Edit Standard Mode – This control allows editing of the standard mode, including motion detection, AZM and
Zero at power up.