Rice Lake MSI-8000 RF Remote Display - ScaleCore Configuration Management Program (ScCMP) - Manual (Page 14)

10 ScCMP Operator’s Manual
3.3 Single Meter View
The single meter view provides a virtual meter interface that is intended for single-load-point weighing
applications. Following is an example single meter view in ScCMP.
Figure 3-6. Single Meter View
The main weight display shows the current load on the system, the units of measure, the weight mode, plus
provides motion indication and center-of-zero (CoZ) indication. The currently selected sensor and the capacity of
the sensor are displayed at the top. The display defaults to the first load sensor in the ScaleCore device. To view
another sensor, click anywhere on the main weight indicator and a dialog box will appear to enter another sensor
number. If there are any errors with the currently selected sensor, a large error message will be displayed on the
screen indicating what the fault is.
The total and total count information is displayed at the bottom left of the single meter view. This is the total
information for the currently selected sensor. The total function supports several modes of manual and auto total.
Details of the total configuration can be viewed in Section 6.0 on page 19.
Note Total and statistics may not be updated if the monitor is not enabled from the Edit menu.
Three setpoint indicators showing the Set/Clear state of each setpoint. These setpoints may not be related to the
currently displayed sensor. Setpoint configuration can be viewed in Section 6.0 on page 19.
The bargraph indicator on the left of the display follows the bargraph function in the ScaleCore device. The first
and last segment values are displayed at the bottom and top of the bargraph respectively. Bargraph configuration
can be viewed in Section 6.0 on page 19.
The scale function controls on the lower right allow the ScaleCore device to be controlled from the computer.
Details of the scale functions are found in Table 3-4.
3.3.1 Scale Functions
Following are the scale functions supported by ScCMP from the Single Meter and ABC Meter views.
Function Description
Zero
Zero the weight on the scale. The zero range may be limited depending on the scale mode. For complete
details see Section 6.0 on page 19.
Zero Return Return to the last zero value. Similar to an 'undo' zero button.
Tare
Remove the weight on the scale and switch to Net weigh mode. Additional details of the Tare function are in
Section 6.0 on page 19.
Tare Clear Remove any tare weight and switch to Gross weigh mode.
Table 3-4. Scale Functions