Rice Lake MSI-8000 RF Remote Display - ScaleCore Configuration Management Program (ScCMP) - Manual (Page 22)

18 ScCMP Operator’s Manual
Custom print formatters can be generated with the help of the custom interface within the Print Formatter Dialog,
shown in Figure 5-2.
Figure 5-2. Print Formatter Dialog (Custom)
The bottom of the Print Formatter Dialog shows the print formatter index that is being edited and the current edit
value in the text box. The value can be typed in, loaded from a pre-configured value or built from the custom
interface.
5.1.2 Print Composite
The print composite lists which of the Print Formatters will be printed and the sequence. The default print
composite '12345' will print all five of the Print Formatter configuration strings in sequence.
Figure 5-3. Print Mode/Composite Dialog
5.2 Print Mode
The Print Mode defines how/when the device will print the configured information. Following are the typically
supported print modes.
• Disabled – Device will not print.
• On Command – A button must be pressed, or command sent for the device to print.
• Stable Load – When a load is picked up and stabilized (no motion) the device will print.
• Continuous – The device will continuously print with the interval defined by the Print Mode.