Rice Lake MSI-8000 RF Remote Display - ScaleCore Configuration Management Program (ScCMP) - Manual (Page 13)

Views 9
3.2.3 Voltage
A ScaleCore device may have voltage sensors. Typically these are used for monitoring power (battery) levels. The
meaning of each voltage sensor is dependent on the device.
Please refer to the specific device User Guide for more details.
Figure 3-5. Data View - Voltage
Note The voltage data will not be updated if the monitor is not enabled from the Edit menu.
Parameter Description
Sensor ID Typical range 5-7 for voltage sensors.
Status Current status of the sensor.
Value The measured voltage value.
Units The current units of measure (Volt).
Table 3-3. Voltage Parameters