Rice Lake MSI-8000 RF Remote Display - ScaleCore Configuration Management Program (ScCMP) - Manual (Page 31)

Advanced Configuration 27
6.6 DAC Channels
The advanced DAC Channels view provides a list of all DAC channels and their associated configuration.
Note DAC outputs are not available on all products.
Figure 6-7. Configuration View - DAC Channels
6.6.1 Parameters
Table 6-6. DAC Channel Parameters
Parameter Description
Channel DAC channel range 0 to 1.
Calibrated Indicates the DAC channel is calibrated.
Enabled Indicates the DAC channel is enabled.
In Cal Indicates the DAC channel is in calibration.
Manual Mode Indicates the DAC channel is in manual mode.
Sensor ID Source Sensor ID. Range 0 to 16.
Units Source Sensor value unit.
Value Type Source Sensor value type.
Value Minimum Source sensor value for min span point of DAC output.
Value Maximum Source sensor value for max span point of DAC output.
6.6.2 Controls
Calibrate DAC – Provides an interface to calibrate the DAC outputs. See Section 4.2.1 on page 15.
Manual DAC Tool – Provides a manual control of DAC outputs for diagnostic and testing. See Section 4.2.2 on
page 16.
Edit DAC Configuration – The edit DAC configuration dialog allows complete configuration of the DAC
parameters. This configuration associates the DAC with an input sensor and scales the DAC output from the sensor
input as desired.