Mercedes-Benz CL-Class 2013 Owners Manual - Manual (Page 489)

intervals than those prescribed. You could
otherwise cause engine damage or damage
to the exhaust gas aftertreatment.
Follow the instructions in the service
interval display regarding the oil change.
Otherwise, you may damage the engine and
the exhaust gas aftertreatment.
The engine oils are matched to the
performance of Mercedes-Benz engines and
service intervals. You should therefore only
use engine oils and oil filters that are
approved for vehicles with maintenance
systems.
For a list of approved engine oils and oil filters,
consult an authorized Mercedes-Benz
Center. Or visit the website
http://bevo.mercedes-benz.com.
The table shows which engine oils have been
approved for your vehicle.
Model Engine
model
MB
Approval
CL 550
4MATIC 25
278 229.5
CL 600 275
CL 63 AMG 26 157
CL 65 AMG 26 275
i MB approval is indicated on the oil
containers.
Filling capacities
The following values refer to an oil change
including the oil filter.
Model Capacity
CL 550 4MATIC 27 9.0 US qt (8.5 l)
CL 63 AMG 10.0 US qt (9.5 l) 28
CL 600
CL 65 AMG 9.5 US qt (9.0 l)
Additives
!
Do not use any additives in the engine oil.
This could damage the engine.
Engine oil viscosity
Viscosity describes the flow characteristics
of a fluid. If an engine oil has a high viscosity,
this means that it is thick; a low viscosity
means that it is thin.
Select an engine oil with an SAE (viscosity)
classification suitable for the prevailing
outside temperatures. The table shows you
which SAE classifications are to be used. The
low-temperature characteristics of engine
oils can deteriorate significantly, e.g. as a
result of aging, soot and fuel deposits. It is
therefore strongly recommended that you
carry out regular oil changes using an
approved engine oil with the appropriate SAE
classification.
25 BlueEFFICIENCY
26 Only SAE 0W-40/SAE 5W-40 engine oils may be used.
27 BlueEFFICIENCY
28 Including external oil cooler.
Service products and filling capacities
487
Technical
data
Z