Comand, System settings – Mercedes-Benz CL-Class 2013 Owners Manual User Manual
Page 133
Individualization
Introduction
You can use the individualization function to
fine tune the Voice Control System to your
voice and therefore improve voice
recognition. This means that other users'
voices will not be recognized as easily. For
this reason this function can be switched off.
Individualization comprises two parts and
takes approximately 5 minutes. It consists of
training the system to recognize a certain
number of digit sequences and voice
commands.
Starting new individualization
Individualization can only be started when the
vehicle is stationary. Before starting, switch
off all devices or functions which could
interfere, such as the radio or the navigation
system. After starting the session, the system
guides you through the training with spoken
instructions.
X
Select
Vehicle
in the main function bar by
turning cVd the COMAND controller and
press W to confirm.
X
Select
System
by turning cVd the
COMAND controller and press W to
confirm.
X
Select
Voice Control
and press W to
confirm.
X
Select
Start New Individualization
and press W to confirm.
You see and hear a prompt asking whether
you would like further information.
X
Select
Yes
or
No
and press W to confirm.
If you select
No
, the first part of
individualization begins. You will be asked
whether you would like to train digits or
voice commands.
If you select
Yes
, you will see and hear
information on the individualization
process. The first part of individualization
then begins automatically.
X
To close the display: press W the
COMAND controller.
You will be asked whether you would like
to train digits or voice commands.
At the end of the first part, a prompt will
appear asking whether you wish to begin the
second part.
X
Select
Yes
or
No
and press W to confirm.
If you select
No
, individualization will be
canceled. The data from the first part is
stored automatically.
If you select
Yes
, the second part will begin.
Individualization is completed at the end of
the second part. You will see a message to
this effect. The data from the second part is
stored automatically.
System settings
131
COMAND
Z