Mercedes-Benz CL-Class 2013 Owners Manual - Manual (Page 165)

Displaying real-time traffic reports
X If necessary, switch to navigation mode
and show the menu (
Y
page 137).
X Select Traffic in the navigation system
menu bar by turning cVd the COMAND
controller and press W to confirm.
If you see the No traffic messages.
message:
This means that:
R no traffic reports have been received yet.
R no traffic reports are available.
X To cancel the search: select Cancel .
X To close the message window: select
OK .
If there are any traffic reports, a list is shown.
The content of the list varies depending on
whether route guidance is active or not.
List of traffic reports
X
To show the traffic report list: select
Display All Messages by turning cVd
the COMAND controller and press W to
confirm.
The list shows all the roads, areas or regions
for which traffic reports are available.
1 State or province recognition
2 Road affected
i A traffic report may refer to an area or a
region, e.g. if visibility is impaired due to
fog.
X
To read a traffic report: select a road, an
area or a region.
X To show a traffic report: select a road, an
area or a region and press W to confirm.
You will find an example of a traffic report
below.
X To exit the list: slide XVY the COMAND
controller once or several times.
Example: traffic report
1 Country code
2 Road, area or region affected by traffic
reports
3 Direction
4 Report 1 of 8 for the road affected
5 Last exit/intersection before the affected
route section starts
Navigation
163
COMAND
Z