Kontron JRexplus-LX - Manual (Page 17)

KTD-S0001-C Page 13 Graphics Interface
JRexplus LX User's Guide
7.2 Flat Panel Connectors
The LVDS interface for the flat panel is available through the X18 connector (30 pins) on the bottom side of
the board. The implementation of this subsystem complies with the JILI specification of KONTRON Tech-
nology A/S. Another option for connecting a display to the JRexplus LX is a (LV)TTL compatible 18 bit RGB
interface available on X17 (32 pins). A variety of cables for different display types are available from
KONTRON. Please refer to the actual
Display Cable Guide on the same product web site.
7.2.1 JILI30 Connector
Header Pin Signal Name Function
1 FTX0- First channel data output 0 (negative)
2 FTX0+ First channel data output 0 (positive)
3 FTX1- First channel data output 1 (negative)
4 FTX1+ First channel data output 1 (positive)
5 FTX2- First channel data output 2 (negative)
6 FTX2+ First channel data output 2 (positive)
7 GND Ground
8 FTXC- First channel clock output (negative)
9 FTXC+ First channel clock output (positive)
10 FTX3- First channel data output 3 (negative)
11 FTX3+ First channel data output 3 (positive)
12 N.C. Not connected
13 N.C. Not connected
14 GND Ground
15 N.C. Not connected
16 N.C. Not connected
17 GND Ground
18 N.C. Not connected
19 N.C. Not connected
20 N.C. Not connected
21 N.C. Not connected
22 N.C. Not connected
23 N.C. Not connected
24 GND Ground
25 SDA I2C data line
26 DATAENA Data enable output
27 SCL I2C clock line
1
30
28 - 30 VCC 1) Power +3.3V or +5V
Attention: The JILI30 interface supports only the VESA FPDI standard.