Elecraft KPA500 Kit Assembly Manual - Manual (Page 39)

38
Front Panel Assembly
Locate the front panel and remove any masking tape found on the inside (partially painted) surface.
Install the standoffs in the inside of the front panel as shown in Figure 56. Include the plastic bezel on the
front held by the four 2-56 screws.
Figure 56. Installing the Front Panel Standoffs and Bezel.
Remove the front panel board from its ESD-safe envelope. Take care not to disturb the alignment of the
LEDs. Install the single square and 18 rectangular key caps as shown in Figure 57. The key caps simply push
onto the shafts of the switches. Be sure you install the rectangular caps horizontally so they will fit through the
openings in the front panel sheet metal.
Figure 57. Installing Key Caps on Front Panel Board.