Elecraft KPA500 Kit Assembly Manual - Manual (Page 3)

2
WARNING
Dangerous Voltages
Inside the KPA500 After It Has Been
Connected to Mains Power
When you have completed assembling your kit, turn to your
Owner’s manual to install and configure it properly before
applying mains power or attempting to operate it.
If you open the KPA500 after installing it and applying mains
power:
1. Turn off the KPA500 by tapping the front panel ON switch and
wait until the fan stops. (The fan drains the power supply to a
safe voltage.)
2. Place the rear panel rocker switch in off (O) position and
disconnect mains power from the rear panel.
There are no dangerous voltages present in the KPA500
during the assembly of the kit if you follow the procedures
in this manual.