Dave Smith Instruments PRO 2 - Manual (Page 62)

52 Sequencer Dave Smith Instruments
At this point you can either start the sequencer running and record
the modulation values in real time or input the values step by step
with the sequencer stopped.
Holding down the
track select
button then pressing a numbered sequencer
step LED (1-16) is a quick way to select a sequencer track for editing. Additionally,
holding down the
track select
button then turning a front-panel parameter knob is a
quick way to select a parameter to sequence.
To sequence Filter 1 cutoff in real time:
1. Press
play
/
Stop
to start the sequencer running.
2. Press and hold the
record
button.
3. As the sequencer cycles through its steps, turn the
cutoff
knob for Filter 1.
Changes in cutoff frequency are recorded as individual steps on Track 2.
4. When you’re done, release the
record
button.
5. To stop playback, press
play
/
Stop
again.
When you’re recording parameter values in real time, be aware of where and
when the sequence loops back around to its beginning or you might inadvertently
overwrite some of your values.
To sequence Filter 1 cutoff step-by-step:
1. Make sure the
Sequencer
button is on.
2. If the sequencer track editor isn’t already visible for Track 2, press and
hold the
track Select
button then press sequencer step LED 2.
3. To go to step 1 of the sequence, press and briefly hold step LED 1.
4. Turn soft knob 1 (
value
), or turn the
Step value
knob, or turn the front-
panel Filter 1
cutoff
knob to set a value.
5. To go to step 2 of the sequence, press and briefly hold step LED 2.
6. Turn soft knob 1 (
value
) or turn the
Step value
knob to set a value.
7. Repeat steps 5 and 6 for each step in the sequence until finished.
8. To trigger the sequence, press
play
/
Stop
.