Dave Smith Instruments PRO 2 - Manual (Page 61)

51 Pro 2 Operation Manual Sequencer
Use the
bpm
,
clock divide
, or
tap tempo
controls to adjust sequencer playback
speed.
To transpose a sequence up or down, hold down a note on the keyboard
above or below middle C. Middle C plays the sequence as recorded. For greater
range, use the Transpose Up or Transpose Down buttons.
To record over an existing note sequence:
1. Make sure the
Sequencer
button is on.
2. If a sequence is running, press
play
/
Stop
to stop it.
3. Press the
record
button.
4. Play different notes on the keyboard. The numbered step LEDs indicate
which step you’re on.
5. When you’re done, press
play
/
Stop
to listen to the new sequence.
To erase an existing sequence:
1. Press and hold the
track Select
button.
2. Turn soft knob 1 (
Select track
) to select the desired sequencer track.
3. Press soft key 4 to execute the
clear track
command.
4. Release the
track Select
button.
Recording Additional Sequencer Tracks for Modulation
Track 1 of the sequencer is permanently routed to the oscillators. But
other sequencer tracks can be routed to any modulation destination.
Here’s how to sequence filter cutoff modulation on Track 2.
To modulate Filter 1 cutoff frequency using sequencer Track 2:
1. Press and hold the
track Select
button then press sequencer step LED
2. (Alternatively, turn soft knob 1 (
Select track
) to select track 2.)
2. While continuing to hold down the
track Select
button, turn soft knob
4 (
deSt
) to select f1
freq
.
3. Release the
track Select
button.