Compex Technologies WP11A+ - Manual (Page 49)

Chapter 7 Setting up WAN using Wireless Routing Client
39
Chapter 7 Setting up WAN using Wireless Routing Client
Setting Compex WP11A+ as a wireless routing client enables you to access to the internet
through wireless method. The PCMCIA LAN card will act as a WAN port. It will communicate
with an Access Point and then from there, we can access to Internet through the ADSL/Cable
modem which is connected to the Access Point. In this way, the Ethernet port of Compex
WP11A+ can be used to connect to other networking devices, such as switches to cater for more
PCs.
7.1 Setting up Compex WP11A+ as Wireless Routing Client
1. Connect a crossover cable from the Ethernet port of the Compex WP11A+ to your
workstation.
Figure 7.1a Connect Compex WP11A+ to PC
2. Power on both your workstation and the Compex WP11A+. The WLAN LED
should light up, indicating the connection has been established.
3. You may start to configure the Compex WP11A+ before connecting to the Internet.
Please refer to “Configuring Compex WP11A+ as Wireless Routing Client
through Web Interface” on Page 41.
WP11A+
Workstation