HP 48G - Manual (Page 12)

Setting the Time and Date
1. Open llie TIME application,
choose
ime and date:
ISET TIME AND OATE^^^^
TIME: W Í - 4 5 - 5 7 ñM
DATE: 1 3 /94 M.-'D/Y
ENTER HOUR
miPuTiai
2. Type the liour, minutes, and seconds, pres.sing fEIMTER) after
each.
3. (optional) If you want the clock to report the time using 24-hour
format, press d D until 24.............. hr is displayed.
4. Press to advance the highlight, and then type the day, month,
and year, pressing (ENTER 1 after each.
5. (optional) If you want the clock to report the date using
day-month-year format, press (V-) until D„ Y is displayed.
6. Press OK , once everything is set as you wish.
Setting the Beeper, Clock, and Fraction Mark
1. Open the MODES utility:
cs
m№m. cflLcuLflTaB MODES
NUMEER FORMAT- H151
ANGLE MEASURE: Degrees
COORD SYSTEM: Rect-anqular
¡¿EEEP _ CLOCK _FM..
CHOOSE NUMEER DISPLAY FORMAT
2. (optional) If you want to turn the beeper
o f f ,
move the cursor
to the tsEEiPER field, and press ...............¡11.: so that the check-mark
disappears.
3. (optional) If you want to continuously display the date and time
on the main calculator screen, move the cursor to the CLOCK
field and press
so that the check-mark appears.
4. (optional) If you want to use the comma instead of a decimal
point as the fract.ion mark, move the cursor to the
press
CHK so that the check-mark appears.
-5. Once you ha^•e set the options as you wish, press U
field and
1-4 Start Here