Dell 1600n Multifunction Mono Laser Printer - Manual (Page 179)

Repairs to certified equipment should be coordinated by a representative designated by the supplier. Any
repairs or alteration made by a user to this equipment, or equipment malfunctions, may give the telephone
communications company cause to request the user to disconnect the equipment.
Users should ensure for their own protection, that the electrical ground connections of the power utility,
telephone lines, and internal metallic water-pipe system, if present, are connected together. This precaution
may be particularly important in rural areas.
NOTICE: Users should not attempt to make such connections themselves. Contact the appropriate
electric inspection authority, or electrician, as appropriate.
NOTE: The REN assigned to each terminal device provides an indication of the maximum number of
terminals allowed to be connected to a telephone interface. The termination on an interface may
consist of any combination of devices subject only to the requirement that the sum of the RENs of all
the devices does not exceed the number five.
The REN for the internal modem as stated on the IC regulatory label located on the bottom of the computer
is 0.6 B.
The following information is provided in compliance with IC regulations:
Dell Inc.
One Dell Way
Round Rock, TX 78682 USA
512-338-4400
CE Notice (European Union)
Marking by the symbol indicates compliance of this Dell computer to the EMC Directive and the Low
Voltage Directive of the European Union. Such marking is indicative that this Dell system meets the following
technical standards:
EN 55022 - "Information Technology Equipment - Radio Disturbance Characteristics - Limits and
Methods of Measurement."
EN 55024 - "Information Technology Equipment - Immunity Characteristics - Limits and Methods of
Measurement."
EN 61000-3-2 - "Electromagnetic Compatibility (EMC) - Part 3: Limits - Section 2: Limits for Harmonic
Current Emissions (Equipment Input Current Up to and Including 16 A Per Phase)."
EN 61000-3-3 - "Electromagnetic Compatibility (EMC) - Part 3: Limits - Section 3: Limitation of
Voltage Fluctuations and Flicker in Low-Voltage Supply Systems for Equipment With Rated Current Up
to and Including 16 A."
EN 60950 - "Safety of Information Technology Equipment."
NOTE: EN 55022 emissions requirements provide for two classifications: