Dell Inspiron 7500 - Manual (Page 130)

4. Remove the 10-mm screw and 20-mm screw from the left hinge saddle and remove the saddle.
5. Disconnect the LED cable from connector J6 on the system board.
6. Remove the 6-mm screw from the plastic frame, remove any tape, and remove the plastic frame.
RJ-11 Card Removal
Figure 34. RJ-11 Card Components
1 4-mm screw
2 RJ-11 card
To remove the RJ-11 card (see Figure 34), perform the following these steps:
1. Remove the 4-mm screw securing the RJ-11 card to the system board.
2. Lift the card off the system board.
System Board Removal
Figure 35. System Board Components
This procedure assumes that you have removed the PC Card heat sink and hinge saddles . To remove the system board (see Figure 35), perform
the following steps:
1. Remove the three 4-mm screws from the bottom of the computer.
2. Remove the system board from the bottom case.
2 RJ-11 card
1 4-mm screws (3)
2 System board