Exploded view of palmrest assembly – Dell Inspiron 7500 User Manual
Page 122
This procedure assumes that you have removed the
. To remove the 15.4-inch LCD panel (see
Figure 23), perform the following steps:
1. Remove the left hinge cover by removing the screw cover and screw
2. Remove the center cover by removing the three screw covers and screws.
3. Disconnect the LCD wire harness from connector JP3 on the system board.
4. Remove the two Phillips screws on the LCD wire harness on the JP3 connector.
Use a dental pick or flat-blade screwdriver to pry up each end of the connector to release it.
5. Close the display.
6. Remove the four 6-mm screws that secure the two hinges to the hinge saddle extensions.
7. Unlatch the display and lift the assembly off the computer base.
Palmrest Component Assembly
Figure 24. Exploded View of Palmrest Assembly
1 LCD wire harness
2 Connector JP3
3 Hinge saddle extensions (2)
4 Hinges (2)
5 6-mm screws (4)
6 Center cover
7 Left hinge cover
8 6-mm screws (3)
9 Screw covers (4)
10 5-mm screw (1)