Dell 3110cn Color Laser Printer - Manual (Page 143)

Auto*
Detects the Ethernet settings automatically.
10Base Half
Uses 10base-T half-duplex.
10Base Full
Uses 10base-T full-duplex.
100Base Half
Uses 100base-TX half-duplex.
100Base Full
Uses 100base-TX full-duplex.
TCP/IP
Purpose:
To specify the TCP/IP settings for the wired network. The change becomes effective after the printer is
turned off and then on again.
Values:
IP Mode* 1 Dual Stack
Uses both IPv4 and IPv6 to set the IP address.
IPv4 Mode
Uses IPv4 to set the IP address.
IPv6 Mode* 3
Uses IPv6 to set the IP address.
IPv4 Get IP
Address AutoIP*
Automatically sets the IP address.
BOOTP
Uses BOOTP to set the IP address.
RARP
Uses RARP to set the IP address.
DHCP
Uses DHCP to set the IP address.
Panel
Enables the IP address entered on the operator panel.
IP Address
Sets the IP address allocated to the printer by using the keys on
the operator panel.
Subnet Mask
Sets the subnet mask.