Dell 3110cn Color Laser Printer - Manual (Page 384)

If a BS code is found at the beginning of a line, the print position of the next character will be located
at the left of the beginning of the line.
When there are multiple tab codes in one line, the tab position may be off as a result of automatic line
feed. In such case, use the -I or -w option.
The number of columns specified by the -w option is not the actual number of printed characters. The
actual number of single-byte characters to be printed is derived by deducting the output column
position (outcolumns) specified by the o option from the number of columns specified by the -w option.
The -mg option cannot be specified when -w, -l, -o, and -L option are specified.
The start positions of margin of the margin command (-mg=u:b:r:l) are not set against the edge of
the paper. The margins are set against the printable area of the paper allowed by the printer.
Use the -ps option only when a PostScript file that contains no %! at the beginning of the file is used as
the PostScript file. If a normal text file is input, it will not function correctly.
In HP-UX, txt2ps2 considers files written by PostScript that contain %! at the beginning of the file as
the PostScript files. To print PostScript files as text files, specify the TX option. With this option,
PostScript files will be processed as text files.
sunras2ps2 (Solaris)
Format
/usr/local/dellbin3110/sunras2ps2 [-d] [-D] [-Itray-input] [-t] [-r] [-n] [-l=left ,bottom]
[-s=width ,height] [-S=width] [-E] [-Nc=copies] [-Cl] [-Hd=position: format] [-Hffont] [-MSI]
[-M=type] [-Mfo=mode] [-Pon] [-St=mode] [-Sp] [-Sb] [-Cm=mode] [-Pr=mode] [-Cc=mode] [-
Gc=mode] [-Sc=mode] [-Gg=mode] [-Ct] [-Br= mode] [-RGBc= mode] [-RGBPr= mode] [-RGBTp= mode]
[-Cb=cyan-low:cyan-middle:cyan-high:magentalow:magenta-middle:magenta-high:yellow-
low;yellow-middle:yellow high:black-low:black-middle:black-high] [-
Hld=PrintType:UserID:Password:DocumentName] [-Jown= jobownername:password] [filename...]
Function
Reads SunRaster data, converts it to the PostScript language program and writes to standard output. If the
filename is not specified, the standard input will be taken as the command input. SunRaster files with a pixel
depth of 1, 8, 24, and 32 bits can be specified.
sunran2ps2 takes filename as having been created in 72dpi and calculates the output size. Thus, to convert
SunRaster files created in other resolutions, specify the size option (-s, -S) explicitly.
Option
-d
Enables the short-edge binding feature. When it is specified, the printing direction or position will be
adjusted and both sides of the paper printed so that the shorter edge of the pages can be bound. This
option is available only when the optional duplexer is installed on the printer.