Dell PowerEdge R905 - Manual (Page 90)

90
Installing System Components
NOTE:
TOE Operating system support and the Microsoft
®
scalable network pack
are required for TOE functionality.
NOTE:
When future NIC functionality is supported, you must replace the original
TOE/iSCSI hardware key with a new hardware key.
1 Turn off the system, including any attached peripherals, and disconnect
the system from its electrical outlet.
2 Open the system. See "Opening the System" on page 67.
3 Locate the TOE/iSCSI key connector on the system board (see
Figure 6-1).
If you have an expansion card installed in slot 7, you may have to remove
the card. See "Removing an Expansion Card" on page 83.
4 Insert the TOE/iSCSI key into the connector onto the board. See
Figure 3-16.
Figure 3-16. Installing a TOE/iSCSI Key
5 If applicable, reinstall the expansion card in slot 7. See "Installing an
Expansion Card" on page 80.
1 TOE/iSCSI key 2 TOE/iSCSI key connector
1
2