Dell PowerEdge R905 - Manual (Page 103)

Installing System Components
103
12 Pull the socket-release lever 90 degrees upward until the processor is
released from the socket. See Figure 3-20.
Figure 3-20. Removing and Installing the Processor
13 Open the processor shield and then lift the processor out of the socket.
Leave the release lever up so that the socket is ready for the new processor.
NOTICE:
Be careful not to bend any of the pins on the socket when removing the
processor. Bending the pins can permanently damage the socket and system board.
Installing a Processor
1 Unpack the new processor.
2 Align the processor with the two socket keys on the socket. See
Figure 3-20.
1 socket-release lever 2 processor
3 processor shield 4 socket keys (2)
5 socket
2
4
5
1
3