Dell PowerEdge R905 - Manual (Page 59)

Using the System Setup Program
59
NOTE:
You can use the Password Status option in conjunction with the System
Password and Setup Password options to further protect your system from
unauthorized changes.
Deleting or Changing an Existing System Password
1 When prompted, press to disable the existing system
password.
If you are asked to enter your setup password, contact your network
administrator.
2 Enter the System Setup program by pressing during POST.
3 Select the System Security screen field to verify that the Password Status
option is set to Unlocked.
4 When prompted, type the system password.
5 Confirm that Not Enabled is displayed for the System Password option.
If Not Enabled is displayed for the System Password option, the system
password has been deleted. If Enabled is displayed for the System
Password option, press the key combination to restart the
system, and then repeat steps 2 through 5.
Using the Setup Password
Read the information in the following sections to assign or change your setup
password.
Assigning a Setup Password
You can assign (or change) a setup password only when the Setup Password
option is set to Not Enabled. To assign a setup password, highlight the Setup
Password option and press the <+> or <–> key. The system prompts you to
enter and verify the password. If a character is illegal for password use, the
system beeps.
NOTE:
The setup password can be the same as the system password. If the two
passwords are different, the setup password can be used as an alternate system
password. However, the system password cannot be used in place of the setup
password.
You can use up to 32 characters in your password.