Dell PowerEdge R905 - Manual (Page 78)

78
Installing System Components
To access the PEM board, remove the cooling shroud. See Figure 3-9.
Figure 3-9. Removing and Installing the PEM Cooling Shroud
Replacing the PEM or PEM Shell
1 Replace the cooling shroud
2 Rotate the PEM so the PEM board (4-processor systems) or air baffles (2-
processor systems) face downwards.
3 Rotate the PEM handle to the fully open position.
4 Align the three guide pins on each side of the PEM with the corresponding
slots in the sides of the chassis. See Figure 3-7.
1 cooling shroud 2 alignment pins (4)
3 snaps (4)
2
3
1