beautypg.com

Dell OptiPlex E1 User Manual

Page 86

background image

Configuration Manager.

ERROR: Could not read

NVS, Error=Internal

Error Code.

An attempt to read the

NVRAM failed.

See the chapter titled "Getting Help" in

your Diagnostics and Troubleshooting

Guide for instructions.

ERROR: Failed NVS write.

Error=Internal Error

Code.

An attempt to write to

NVRAM failed.

Run the Dell Diagnostics to verify the

integrity of your system NVRAM. See the

chapter titled "Running the Dell

Diagnostics" in your Diagnostics and Troubleshooting

Guide for instructions.

If you are unable to determine the cause of

the error, see the chapter titled "Getting

Help" in your Diagnostics and

Troubleshooting Guide for instructions.

ERROR: Failed to

activate device, CSN=Card

Select Number.

A Plug and Play

expansion card could not be

activated.

Use the following procedure:

1. Exit the ICU and turn off your system.
2. Remove the Plug and Play expansion

card that could not be activated.

Follow steps 2 through 6 of
"

Removing an Expansion Card

",

and then return to this procedure.

3.

Reinstall the Plug and Play expansion

card.

Follow steps 5 through 9 of

"

Installing an Expansion Card

", and

then return to this procedure.

If you still receive the error message,

contact the manufacturer of the Plug and Play

expansion card for assistance.

WARNING:

Could not

configure Plug and Play Card

Name.

WARNING:

Could not

configure PCI device,

ID=DeviceID.

Failed to configure Number

of Total Count Plug and

Play ISA devices. Use

your system's configuration

utility to resolve conflicts.

Press any key to continue.

The card(s) mentioned

are not fully configured

due to resource conflicts.

If you have documentation that lists the

allowable resource values for your Plug

and Play or PCI expansion card, you can

use the following procedure to locate and

resolve the resource conflict.

NOTE: If you do not have documentation

listing the allowable resource values, see

the corrective action for these messages

on the following page.

1. Start the ICU.

Any Plug and Play or PCI expansion
cards that could not be configured
should be marked config err on the
list of cards in the ICU window.