Dell OptiPlex E1 - Manual (Page 84)

The conflicting
resource was:
resource.
one at a time, beginning with the new card and resolving resource
conflicts as they arise. See "
Removing a Card " and " Adding a Listed
Card " or " Adding an Unlisted Card " for instructions.
If you cannot resolve the resource conflict by any of the preceding
methods, remove the new card. If you were modifying an existing
card, reset the modified card to its previous resource value.
The
configuration
(.cfg) file used
by
the ICU for this
card is now
invalid
or does not
exist.
Do you wish to
load
the file?
No
configuration
(.cfg) file exists
for the card
being
modified. Do
you
want to load
one?
This message appears
when you try to add a
listed card and the
configuration file for this card
has been corrupted or
deleted from the
database.
This message appears when
you modify a card and its
configuration file does not
exist or has been deleted.
You can get a copy of the configuration file from the original ISA
Configuration Utility Diskette that you used to create the backup ICU diskette.
Use the following procedure:
1. Insert the original ISA Configuration Utility Diskette into drive A.
2. Change to the db subdirectory on the diskette drive.
For example, type cd a:\db.
3. Use a text editor to search the icu.ndx file for the card ID of the
card you want to add or modify.
The name of the configuration file is part of this card ID. For example,
if the card ID is ICU0200, the configuration file is !icu0200.cfg
4. Copy the configuration file from the original ICU diskette to the
backup diskette.
This is an EISA
system. Use an
ECU,
not the ICU, to
configure your
system.
This message appears if
you attempt to run the ICU on
an EISA system.
To use the ICU, you must load the utility onto a non-EISA system.
You have
added a
card using
settings
different from
factory default.
Reconfigure the
card to the
settings in the
next
display (see the
card's manual)
before installing
it.
This message can appear
in two situations:
You added an ISA
expansion card,
selected OK, and the
ICU had to use
resource values
different from the
card's defaults to
avoid conflicts.
You added an ISA
expansion card,
selected Advanced,
and chose resource
values different from
Make note of the new card configuration shown in the Card Resource Usage
dialog box displayed after this message. Change jumper settings on the ISA
expansion card to match the new card configuration.