Dell OptiPlex E1 User Manual
Page 83
The ICU has
successfully
configured all
Plug
and Play cards
in
your system.
For
the new
configuration to
take
effect, save the
configuration,
then
reboot your
system.
The ICU has successfully
configured all of the Plug
and Play expansion cards
that were not configured
by the Configuration
Manager.
To accept these settings, save the configuration information into NVRAM by
selecting Exit from the File menu and then selecting Yes to save. You must
reboot your system for these settings to take effect.
The loaded
card is
not a category
card. Press OK
to
proceed.
The category you have
chosen is not the correct
category under which to
add this card.
Select OK. The ICU automatically opens the correct category's dialog box.
Continue the procedure for adding the card as described in "
" or "
No more DMA
values
can be added.
No more
interrupt
values can be
added.
No more
memory
values can be
added.
No more I/O
port
values can be
added.
No more values are
available for the resource you
are trying to add or
modify.
The maximum number of values for each resource is as follows:
4 DMA channels
7 IRQ lines
9 memory address blocks
20 I/O ports
To free values for the resource you are trying to add or modify, delete some
of the values listed in the resource box for the card. If your card requires all
of the values listed, contact your card manufacturer to resolve the issue.
The ICU
detects a
resource
conflict
between this
card
and
conflicting_card.
You added or modified a card
that now requires a resource
value already in use by
conflicting_card.
Try each of the following options until the problem is resolved:
Modify the card you are adding so that it uses a different value for
resource. See "
" for instructions.
Modify conflicting_card so that it uses a different value for resource.
See "
" for instructions.
If conflicting_card is not the system board, remove it from the
computer. See "
" in for instructions.
Remove all expansion cards from the ICU, and then add them back