Edge Lighting PSB-400W-24VDC-RGB, 400 Watt 24 Volt DC Power Supply - Manual (Page 6)

6
Operating CDP
1- Turn the light on 2- Change brightness 3- Turn the light off
BRIGHTNESS
Selecting Modes
O N
1 2 3 4 5 6 7
COLOR MODE
O N
1 2 3 4 5 6 7
Configure your CDP by setting the DIP switches on the front:
NOTE: The DIP switches must
remain accessible after installation.
When making changes in the DIP
switch settings, disconnect and
reconnect the power supply to
activate new settings.
CHASE MODE
1- Turn the light on 3- Set Color 2- Activate configuration mode
2 SEC
4- Save color saving
Advanced Operation for Color Mode
TAP TAP
1- Turn the light on 3- Set show speed 2- Activate configuration mode
2 SEC
4- Save color setting
Advanced Operation for Chase Mode
TAP TAP
TAP TAP