Edge Lighting PSB-400W-24VDC-RGB, 400 Watt 24 Volt DC Power Supply - Manual (Page 2)

Installing LED Power Supply with RGB Soft Strip & CDP or
CTP Controller
1: Loosen the four Phillips screws on the front of the power
supply cover to slide the cover off of the case.
2: Carefully pull off the cover from the DVR-RGB-200 driver.
A
COVER
1
CASE
M
DVR
DRIVER
COVER
2
PHILLIPS
SCREW
B
ELECTRICAL BOX
CONTROLLER
CONTROLLER POWER SUPPLY
CONDUIT
CASE
8
DMX CABLE
DMX CABLE
(BELDEN #9841)
4
6
7
3: Connect one end of a red wire to “VDC+” of the controller
terminal and the other end of the red wire to the “+24VDC”
of the power supply terminal.
4: Connect one end of a black wire to “Ground” of the controller
terminal and the other end to the “-24VDC” of the power
supply terminal.
5: Run the black and white line voltage wires coming from
the controller power supply to the power supply case.
6: Connect the white wire to "N" terminal of the controller
power supply.
7: Connect the black wire to "L" terminal of the controller
power supply.
8: Install conduits from controller, main panel (line voltage),
and soft strip to power supply.
9: Run proper DMX cable (Belden #9841 recommended)
with three data wires from controller to the power supply
box.
NOTE: Use a deep double gang boxes to fit the controller
and controller power supply (OT-20-120-240-245
recommended).
2
9
NOTE: Refer to the "Configuring DimWheel" & "Operating
DimWheel" on page 6 & 7 to properly operate the controller.
3